Hi all! We've distilled this year's solar cell summer-solstice tests into a nice, pretty set of PDF files. Want to know the power curves of our solarcells? Check it out here!
The instructions for assembling the Pi v3 and the previous acrylic Pi SAFE are quite similar. The only difference between the models is the location of the LED light pipes, so these Pi3 instructions apply generally to all Pi SAFE versions.
Find 4 of the 4-40 x 3/8" bolts, and put them through the baseplate, and press the spacers on from the other side. Thee bolts will sort of stay put until you can get the Raspberry Pi on the baseplate. (If adding to a VESA mount, do only 2 diagonal screws)
Slide the Raspberry Pi onto the bolts. The Pi is designed for metric M3 hardware, but we're still using imperial #4 hardware, which is a smidge bigger. The bolts may need to be screwed through the holes in the Pi.
Add the #4 nuts, and tighten them down.
Arrange the sides as shows. The sideplate on the top in this image has the long cutout to accommodate a ribbon cable from the 40-pin expansion port. The front faceplate on the right (with the label engravings face-down) is for the communications side. The sideplate on the bottom has the ports for the power, video, and audio I/O.
Align them all up on the baseplate, and use a pair of 4-40 nuts and bolts to lock them in place.
Lay the final side faceplate face-down beside the assembly, and pop the clear lightpipe parts out of their holder. It is not necessary to strip the paper off this part.
Sandwich the two lightpipes together, and push them into the lightpipe indicator hole. They will sit a bit loose until the faceplate is attached to the baseplate.
Carefully assemble this assembly to the baseplate, and finish attaching it with the remaining 4-40 nuts and bolts.
Notch the top plate into the slots in the rear faceplate, and gently flex the frontplate out to let the tab snap into place. You're ready to power up, with full access to the indication LEDs on the Pi mainboard via the lightpipes!
.
Hi all! We've distilled this year's solar cell summer-solstice tests into a nice, pretty set of PDF files. Want to know the power curves of our solarcells? Check it out here!
If you came to the BEAM/WCRG Millennium Games in Calgary last summer, you may have seen Jeff de Boer's lecture on the aesthetic component of robotics. Jeff is a local Calgary artist (recently inducted to the Royal Canadian Order - a huge honor, considering his age), and was interviewed on CBC radio Monday with Shelaugh […]
We are going to be at one of the two coolest shows on earth, the San Francisco Bay Area MAKER FAIRE! (The other coolest show is the Austin version!) So we are packing up shop and heading down to beautiful California where it's warm and not snowing! If you are in the area, have a […]
Well, what a pleasant surprise - a large truck dropped by today and delivered our shipment of GM10 gear motors! They're $12.00/ea or $9.50/ea USD in pairs ($15.50/ea or $12.75/ea in pairs for Canadians) - much less expensive than converting nanoservos!
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.