Plug your ESP32-C6 into this breakout board.

It features a 3.7V lipo battery port (please note power polarity – not all batteries have the red & black wires in the right orientation). When the green light goes off, the lithium battery is fully charged, and the expansion leads out all the IO ports, facilitating the user to connect a variety of sensors.

It also feature two power supply selection: VCC1 and VCC2. The default output voltage of VCC1 and VCC2 is 3.3V. if higher voltage is required, short the PCB pads to get the full battery voltage of ~3.7V. The default 0-ohm resistor is in place to provide 3.3V.