Push Pogo Probe Holder SKU: PPH1
Push Pogo Probe Holder
$1.25 USD
This holder is specially designed for easy installation/replacement of the PP1/3/4/6/8 Pogo Pins
In stock
Description
This holder installed into 1.31mm (0.052″) holes to facilitate the easy mounting and replacement of PP1, PP3, PP4, PP6 & PP8 pogo pins. Ideal if you’re actually using these pins for what they’re designed for, and not robot appendages! Pogo pins press fit into this holder, you may have to give them a little extra push to get them to the bottom of the holder but once they are seated they stay in place quite nicely.
Resources
More Info
Weight | 0.0001 kg |
---|---|
Dimensions | 3 × 0.1 × 0.1 cm |
Only logged in customers who have purchased this product may leave a review.
Related products
-
Magnet
SKU: Mag1These 3/4" Neodymium magnets are very strong. Useful for all kinds of Magbot experiments or just holding posters up on metal surfaces as we like to do!$2.75 USDOut of stock
Read more -
Microchip PIC16F877A
SKU: PIC16F877AThis is the Microchip PIC16F877A microcontroller that is used in our K SV-PIC Brainboard add-on.$7.95 USDIn stock
Add to cart -
Push Pogo Pin 6 – 6 Point
SKU: PP6This 33mm (1.3") long 6-groove tipped pogo pin probe is normally used for electronic JTAG uses, but we used them for bots!$1.25 USDIn stock
Add to cart -
50-Series Push Pogo Probe Holder
SKU: PPH-50This little devices allow you to simply and easily install and replace existing 50-series pogo pins$1.50 USDIn stock
Add to cart -
50-Series Push Pogo Pin – 4-Sided Point
SKU: PP2-50This smaller, 16.4mm long cone-tipped pogo/probe ping is normally used for electronic JTAG uses, but we use them for bots!$1.50 USDIn stock
Add to cart
Reviews
There are no reviews yet.